Various tasks in a woodwork shop, including cutting, shaping, and resawing, need bandsaw blades to ensure perfect cuts whether on thick or thin wood pieces. These blades also take care of the delicate curves of woodblocks, which can’t be done properly with other types of blades out there.
This extremely helpful tool in workshops should be used with necessary safety guidelines to avoid any kind of mishaps. If you follow some band saw safety rules, staying safe on the saw will be much easier.
Here in this article, we have discussed almost every precaution along with some tips for maintaining ultimate safety from your band saw.
Precautions and Safety Measures
If you use a bandsaw, please maintain the following safety rules to prevent accidents while working with the blades.
- Never forget to wear hand gloves, face shields, and safety glasses while using bandsaw blades. These safety gear can reduce the chance of getting injured.
- Always keep your hand a minimum 4 inches away from the cut line, and avoid pushing the woodblock directly into the blade. You can use a push stick instead.
- Adjust the guard about ¼ inch above the wood block so that the blade doesn’t remain uncovered. Use a sharp blade, and check if it is tightly attached or not.
- Always choose wood logs that are flat at the bottom. This makes it easier to slide smoothly without getting stuck in a middle way.
- You will see a lot of small wood pieces lying beside the blade after cutting. Don’t remove them with your hand in the midst of the cutting process, as it can be dangerous and can hurt your hand.
- Don’t stand or let others stand at the right side of the bandsaw while it is running. Always remain on the right side or at the back.
- After turning on the power, let the blade reach its full speed before you start cutting the material. Wait for the blade to stop moving after you turn off the power.
- The blade teeth should face down while working. If you hear any clicking sound, stop the blade immediately as it indicates a crack on the blade.
- For any curve design, turn the bandsaw carefully so that the blade doesn’t get twisted or break while turning.
- Clamping woodblocks to the table is preferred while you are working on that. It prevents the block from sliding over the table.
You may buy the best band saw but if you don’t follow the safety rules you will end up by making an accident. I hope you won’t face any mishap or unwanted situation if you follow these band saw safety rules while using the band saw. Don’t rush or skip any of the above-mentioned steps to save time. Your well-being is way too important than your time.